Skip to main content

CQWW 160 CW 2026

Using a 100W K3 with an L antenna and a small loop RX antenna sometimes helped a bit.


 


Almost all contacts were within Europe. Propagation was poor, with only a brief window on Saturday morning at 07 UTC when some USA signals were heard and workable  and PJ2T  No signals from Asia, 



                    Ranking at closing, shifting up and down from 16th to 9th place.
Labels:

Comments

Post a Comment

Archive

Show more

Popular posts from this blog

IARU R1 70 MHz Contest Report. 19 20 Juli

 26 QSO in CW USB. Op zaterdag wat zwakke signalen uit Engeland, in de avond haast geen signalen meer. Dit was geen FT8 dat was duidelijk...  Op 70MHz is men in Engeland heel actief , voor een grote contest zoals deze IARU R1 24uur zoekt men daar goede locaties op zoals hier M0ICK/P IO84SA ik had QSO nr 4 Michael al 41! . Maar ook op de activity avonden op de Dinsdag avonden van de de maand zijn veel Engelse stations actief . Zo kon ik op de 2e dinsdag  van juni op 1 avond in een paar uur tijd 100QSO's op 70cm 432 MHz in CW USB hoofdzakelijk G's maar ook SM7 6 OZ SP OK DL   zoek  voor de agenda op : https://vhf-uhf.veron.nl/contesten/contestrobot/   On 70 MHz activity in England is very strong. For a major contest like the IARU R1 24‑hour , operators look for good locations, such as M0ICK/P IO84SA . I had QSO number 4, while Michael already had 41! But also during the activity evenings on Tuesday nights each month , many English stations are active. O...
Post a Comment
Read more

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its n...
8 comments
Read more

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjuste...
12 comments
Read more