Skip to main content

UKSMG 6m Summer contest

   UKSMG 50MHz Summer contest


This Saturday 13Z   to Sunday 13Z  was the UKSMG 6m Summer contest.
Only by watching the calendar we know it must be summer.
The heating was on and we needed some extra light. Gray dark skies outside.
After last weeks heath wave it cooled down to 12C. 
Sunday morning signals in the 50MHz band
Most  EU Russia East Southeast CW  some USB mode   UR UT UX YO SV LZ  YU weak 9A
No Italians!  Nothing from North  North East no EA not even EA8 heard
And some direct signals ON DL G

Best DX heard A92GE in CW long CQ 559  but could not copy me running  ACOM1000 power. Not enough to be heard   a DL 200km S-E  had no problem,   guess a higher class PA ..
Since the spectacular 144MHz ES with a half......  QSO 4X/OM2IB  KM75JC 3256km
All ES openings moved to the normal position south all signals gone the signals die out just south of JO33HG.

THe UKSMG 6m summer contest is thé opportunity  for classic CW USB mode QSO
This contest does not allow FT8.
I was expecting to meet all those hams in this contest that hate FT8 so bad...
but where are those pure CW lovers?

UKSMG site

UKSMG Summer Es Contest Rules

The UKSMG welcomes you to the UKSMG Es Summer Contest

Note Rule Changes in Section D for 2021

I expected Section D to be digital mode  FT8 ,but i could not find anything about section D.  I see  section 1 2 3 4 5  where is section D?
  

A. Sections

Entrants may choose from one of the sections below :
  1. Single Operator - Fixed Stations
  2. Single Operator - Portable Stations
  3. 6 Hour - Single Operator - Fixed Stations **
  4. 6 Hour - Single Operator - Portable Stations **
  5. QRP 5 watts max - All Stations
 
Contesting in the DX window 50.100 50.130 and below 50.080 is not allowed
Zero points punishment if you are tuned  the wrong frequency.
Warning message blocks logging update, to late to say pse QSY outside the blocked band section the do it again..
I was surprised but yes, once upon a time there where DX windows.
In those time i had no internet we had 28.885 as 6m chat channel... 
The present DX window  is 50.313 i would think but a CW/phone QSO there is not puniced ..
I would skip this rule in the present FT8 ERA .
Anyway my result 51 QSO  including the invalids.
 
..

 





Labels:

Comments

PE4BAS, Bas said…
Heb je een paar maal beluisterd Jaap. Sterk signaal maar kwam weinig voor je terug. Lijkt me frustrerend vooral als je ziet wat er allemaal op FT8 gewerkt word op dat moment. 73, Bas
June 6, 2021 at 10:05 PM
Post a Comment

Archive

Show more

Popular posts from this blog

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its n...
8 comments
Read more

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjuste...
11 comments
Read more

BIJZEN mast en ontwerp fouten.

In 2013 heb ik een Bijzen aluminium mast 3 x7m  opgehaald  bij iemand die hem niet mocht plaatsen Gemeente Oss  dat zegt misschien al genoeg.. Pas in 2018 heb ik hem geplaatst had ik veel eerder moeten doen. Mooie mast, mijn xyl vond hem zelfs mooi. Hij is licht, de 3 delen wegen  235kg  het vaste deel 102kg dus het te lieren gedeelte weegt   slechts 133kg + ca 50kg rotor + antennes etc.  De elektrische lier is wel erg zwaar 30kg misschien wel maar die zit onder    Antenne  3ele Steppir  19kG  +  G2500DXC rotor: 3.6kg  + rotorbuis 12 kg  +  kabels 10kg  + 5/7 ele 6m beam. ongeveer 50kg Je moet niet te dichtbij  kijken, dan valt op dat het Aluminium lastwerk heel slordig is gedaan, scherpe bramen aan de lassen waar kabels door kunnen worden beschadigd of haken Er is zeer ! weinig ruimte voor de rotor een YAESU G2500DX past net maar dan ook net  met beetje buigen van  kruisverband. Het...
3 comments
Read more