Skip to main content


VP8ALJ  new one 10M WSPR
TimestampCallMHzSNRDriftGridPwrReporterRGridkmaz
 2015-04-23 07:58  PA0O  28.126045  -26  0  JO33hg  1  VK7AB  QE37ne  16905  84 
 2015-04-23 07:58  PA0O  28.126066  -26  0  JO33hg  1  VK2YW  QF34qu  16362  72 
 2015-04-23 08:06  VK2KRR  28.126040  0  0  QF34mr  20  PA0O  JO33hg  16351  316 
 2015-04-22 09:36  PA0O  28.126053  -20  0  JO33hg  1  VK5MR  PF96lh  15704  79 
 2015-04-22 16:18  PA0O  28.126090  -8  -1  JO33hg  1  VP8ALJ  GD18  13070  219 
 2015-04-22 16:16  VP8ALJ  28.126055  -9  -1  GD18  10  PA0O  JO33hg  13070  37 
 2015-04-22 12:22  PU3WSF  28.126099  -3  -1  GG40kb  2  PA0O  JO33hg  10796  31 
 2015-04-23 08:12  PA0O  28.126065  -26  0  JO33hg  1  JH1DIS  PM95vr  9139  37 
 2015-04-22 09:48  PA0O  28.126064  -24  0  JO33hg  1  JH3APN  PM74tq  9070  40 
 2015-04-22 13:42  ZS6VOL  28.126088  -22  1  KG44df  5  PA0O  JO33hg  9035  347 

Wanted to ad picture from Dropbox and or GoogleDrive
but those programs sometimes do not show all uploaded  pictures.
Also vague in what map you upload 
It is can be very useful if it works right to access files
Google drive does not integrate with this Google blog yet.
Dropbox files can be selected as a local map but not all files are shown
Even after the message:  file added to Dropbox comes up after just uploading a phone picture.
The uploaded file seems not synchronized with this PC.

 TONICA RX80 former DDR Rundfunk Empfanger

I got this receiver for repair  and was surprised by its design 
The 2A fuse was blown for the +/-24V unregulated power to the PA part
But after connecting the power again trough a protective 50OHm the bias was low 200mA adjustable
0-500mA  all looked fine 
And the sound was very good.
Fine clasic receiver

It will be not to long from now that all those clasic FM receivers will be ready for the museum
Since DAB+ will take over
So after loosing the analogue TV  the next is loosing Analog FM BC.   







Labels:

Comments

Post a Comment

Archive

Show more

Popular posts from this blog

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its n...
8 comments
Read more

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjuste...
11 comments
Read more

BIJZEN mast en ontwerp fouten.

In 2013 heb ik een Bijzen aluminium mast 3 x7m  opgehaald  bij iemand die hem niet mocht plaatsen Gemeente Oss  dat zegt misschien al genoeg.. Pas in 2018 heb ik hem geplaatst had ik veel eerder moeten doen. Mooie mast, mijn xyl vond hem zelfs mooi. Hij is licht, de 3 delen wegen  235kg  het vaste deel 102kg dus het te lieren gedeelte weegt   slechts 133kg + ca 50kg rotor + antennes etc.  De elektrische lier is wel erg zwaar 30kg misschien wel maar die zit onder    Antenne  3ele Steppir  19kG  +  G2500DXC rotor: 3.6kg  + rotorbuis 12 kg  +  kabels 10kg  + 5/7 ele 6m beam. ongeveer 50kg Je moet niet te dichtbij  kijken, dan valt op dat het Aluminium lastwerk heel slordig is gedaan, scherpe bramen aan de lassen waar kabels door kunnen worden beschadigd of haken Er is zeer ! weinig ruimte voor de rotor een YAESU G2500DX past net maar dan ook net  met beetje buigen van  kruisverband. Het...
3 comments
Read more