Skip to main content

RUSIAN DX RTTY

Lange tijd alleen WSPR actief door te druk QRL.
Was vrijdag nog in DL   had wat tijd een paar uur gefietst in de omgeving van Juelich beter dan in de file's  in het Rurgebied  te hangen op vrijdag middag.
Daar stond tot 2010 nog een enorm antenne park van de Deutsche Welle in Juelich
http://de.wikipedia.org/wiki/Kurzwellenzentrum_J%C3%BClich
Werkelijk gigantische KG en MG  dipool arrays.
34 masten  tot 110m hoogte met zeer gecompliceerde gordijn antennes.

Alles afgebroken tot op 1  Logperiodische  beam na als Denkmahl.
Het fietspad loopt er vlak langs. Er staat een hek omheen maar er zitten veel openingen in.
Deze logperiodische antenne is denk ik wel een van de grootste in zijn soort bestrijkt het hele korte golf gebied.
Even zo goed een enorme antenne  40m hoog en 30m breed ?  moeilijk te schatten.
Draaibaar systeem word niet meer gebruikt.
Zonde natuurlijk maar zou zo'n kolos nu beter werken dan een normale trap beam?
Er zijn per band slechts een paar elementen actief.






Dit weekeinde weer eens zelf op HF geluisterd.
De verwachting was niet hoog met zeer matige WSPR resultaten de laatste weken.
Dit weekeinde liefst 6 contesten
De All Asian SSB  hmm  SSB daar had ik geen trek in.
CWops  dat zou wel wat zijn maar ik was toevallig net op verkeerde tijd.
Velddag   SSB
LZ open
AGCW
DIGICUP




gekozen voor  Rusian RTTY  toch maar ondanks alles...
Die Russiesche HAMS kunnen er ook niets aan doen.


Opvallend sterke Japanse signalen op 15m  ik kon er een 20 tal werken
hadden er meer kunnen zijn maar ik was te laat gestart en moest al snel weer stoppen.

203 RTTY  in het log   6 punten voor de afdeling





Comments

Archive

Show more

Popular posts from this blog

70MHz IARU contest 19 20 Juli

 26 QSO in CW USB. Op zaterdag wat zwakke signalen uit Engeland, in de avond haast geen signalen meer. Dit was geen FT8 dat was duidelijk...  Op 70MHz is men in Engeland heel actief , voor een grote contest zoals deze IARU R1 24uur zoekt men daar goede locaties op zoals hier M0ICK/P IO84SA ik had QSO nr 4 Michael al 41! . Maar ook op de activity avonden op de Dinsdag avonden van de de maand zijn veel Engelse stations actief . Zo kon ik op de 2e dinsdag  van juni op 1 avond in een paar uur tijd 100QSO's op 70cm 432 MHz in CW USB hoofdzakelijk G's maar ook SM7 6 OZ SP OK DL   zoek  voor de agenda op : https://vhf-uhf.veron.nl/contesten/contestrobot/       Pas op Zondag later in de ochtend ging de band open eerst 9H1PA  daarna vrijwel heel Spanje ,het geduld werd beloond.  gemiddelde  haast 1200km  Ook EA op 70.200 in FM , helaas wel te dicht op USB waardoor een QSO haast niet mogelijk was.   4M station de IC7100 me...

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its n...

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjuste...