Skip to main content

7O6T 30M and AURORA=good low band DX?


Took some days before it was in the online log and  I thought to have worked a slim because of chaos by lids.
Smart operating of the 7O6T team they moved a bit around their QRG to avoid jammers. Nice trick you have to tune around to find them back and make a sneaky QSO. I was noticed first by a cluster spot must admit.
But do not spot them to brag  saying thanks  that will only help the jammers.
That is a drawback of the Reverse beacons they spot the new QRG direct after QSY.


20120506 2203  10104,4 CW   PA0O         599  7O6T            599                  


Tonight again  7004kHz good copy and the same trick moving off the jammers  it was my last band.  Not easy needed lots of calls. 
 9 bands complete in CW now for a DX-pedition  at a relative easy distance  it was not easy because of the QRI and the constant  huge piles from EU.


WSPR   10M today was very poor except for RI1ANF   later heard  in CW  very weak   from S-Shetland Isl.  GC
2012-05-09 13:40  PA0O  28.126074  -14  -1  JO33hg  5  RI1ANF  GC07mt  14056  212 
 2012-05-09 14:58  RI1ANF  28.126112  -22  0  GC07mt  5  PA0O  JO33hg  14056  43 

surprise tonight 160m is in good shape  also 80m is open to VK2UB

TimestampCallMHzSNRDriftGridPwrReporterRGridkmaz
 2012-05-09 20:00  G8JNJ/A  1.838049  -28  0  IO90hx  5  VK2KRR  QF34mr  16950  68 
 2012-05-09 20:20  VK2KRR  1.838152  -28  0  QF34mr  20  G8JNJ/A  IO90hx  16950  315 
 2012-05-09 20:08  VK2KRR  1.838162  -21  0  QF34mr  20  ON5KTO  JO21oe  16508  312 
 2012-05-09 20:02  VK2KRR  1.838162  -22  0  QF34mr  20  ON5KTO  JO21oe  16508  312 
 2012-05-09 20:32  PA0O  1.838078  -22  0  JO33hg  1  VK2KRR  QF34mr  16351  73 
 2012-05-09 20:16  PA0O  1.838078  -14  0  JO33hg  5  VK2KRR  QF34mr  16351  73 
 2012-05-09 20:04  PA0O  1.838078  -11  0  JO33hg  5  VK2KRR  QF34mr  16351  73 
 2012-05-09 20:20  VK2KRR  1.838153  -24  0  QF34mr  20  PA0O  JO33hg  16351  316 
 2012-05-09 20:08  VK2KRR  1.838151  -27  0  QF34mr  20  PA0HCK  JO33ld  16333  315 
 2012-05-09 19:58  PA0HCK  1.838030  -19  0  JO33ld  5  VK2KRR  QF34mr  16333  74 
 2012-05-09 20:22  PA0HCK  1.838030  -23  0  JO33ld  5  VK2KRR  QF34mr  16333  74 
 2012-05-09 20:10  PA0HCK  1.838030  -19  0  JO33ld  5  VK2KRR  QF34mr  16333  74 

Comments

Enno - PF5X said…
That's right. Worked them on both 30 and 40m tonight. On 40m they did move around, on 30m it was not needed because of the skip distance in the dark zone is big enough to make jamming ineffective. Now I hope I'll show up in the log tomorrow ... Pfff.
10-40m CW done, so still need 80m but not sure if I am going to spend time on that band ...

-- Enno, PF5X
pa0o said…
Enno good job they trick out the jammers a bit

Archive

Show more

Popular posts from this blog

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its n...

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjuste...

BIJZEN mast en ontwerp fouten.

In 2013 heb ik een Bijzen aluminium mast 3 x7m  opgehaald  bij iemand die hem niet mocht plaatsen Gemeente Oss  dat zegt misschien al genoeg.. Pas in 2018 heb ik hem geplaatst had ik veel eerder moeten doen. Mooie mast, mijn xyl vond hem zelfs mooi. Hij is licht, de 3 delen wegen  235kg  het vaste deel 102kg dus het te lieren gedeelte weegt   slechts 133kg + ca 50kg rotor + antennes etc.  De elektrische lier is wel erg zwaar 30kg misschien wel maar die zit onder    Antenne  3ele Steppir  19kG  +  G2500DXC rotor: 3.6kg  + rotorbuis 12 kg  +  kabels 10kg  + 5/7 ele 6m beam. ongeveer 50kg Je moet niet te dichtbij  kijken, dan valt op dat het Aluminium lastwerk heel slordig is gedaan, scherpe bramen aan de lassen waar kabels door kunnen worden beschadigd of haken Er is zeer ! weinig ruimte voor de rotor een YAESU G2500DX past net maar dan ook net  met beetje buigen van  kruisverband. Het...