Skip to main content

Perseiden 144MHz 24h psk reporter

 In general  good bursts over 2000k ,but  at very long interval, so a 2-way can start fast but needs a lot of patience to complete 

And we have watched  2 nights with reasonable clear sky bu not a single visible meteorite was observed 


Popular posts from this blog

2011-01-22 DIAMOND X30 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this Diamond collinear 70/2 combi antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size but it is no longer selling i think. This H43 3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its normal vertical mounting position. But take care if you

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjusted at 50mA  5V  The current raises to 150mA  when removing the  negative gate voltage. Where is that internal bias cir

TS472 microphone preamp versus MAX9812

MAX9814  seems the best choice  it has AGC and jumpers for gain setting to max 60dB  will test this one to when arrived.  Received this low noise ST TS472  pre-amp  Diymore from eBay. Main while the 3 transistor pre-amp with AVR earlier down in the blog works fine. This TS472 IC is special designed for microphones  electret or magnetic and i was curious to find out how such integrated device performs. With the magnetic  200 OHm Peiker element the signal is fine although not as sensitive as with an electret element. The maximum un-clipped output is about 2Vtt. It did not match the low impedance mike input of the Condor as it is at first test. Minimum drive load is 10k.  An emitter or source driver is needed behind the TS472 and  low impedance tranceivers like the Condor.  No documentation is supplied with it but the PCB looks similar to the  ST  demo board TS472 PCB  well designed.   The standby pad must be +    ,  minus = gnd  will switch to standby. Left fl