Skip to main content

WSPR 70 / 50 MHz over last week

13-7-2016   50.4358  D4C/B  hrd 569  HK76mv    evening  + ES  1 skip Italy I0


70MHz wspr

2016-07-08 01:52  PA0O  70.092550  -22  -2  JO33hg  5  M0NKA  IO92ak  583  264 
 2016-07-07 18:26  G6HSM  70.092474  -25  -3  JO01oe  1  PA0O  JO33hg  435  56 
 2016-07-07 15:12  PA0O  70.092549  -23  -4  JO33hg  5  DB0ZDF  JN49cx  382  163 
 2016-07-13 14:34  G3THQ  70.092540  -27  0  IO91un  5  G0MJI  IO83ni  265  320 
 2016-07-07 22:24  PA0JME  70.092424  -25  -1  JO21ri  20  DB0ZDF  JN49cx  247  127 
 2016-07-07 17:32  PA0JME  70.092436  -24  0  JO21ri  20  PA0O  JO33hg  227  20 
 2016-07-08 15:44  PA0JME  70.092554  -12  -1  JO21ri  20  PA2GP  JO33hb  206  22 
 2016-07-07 16:34  PA4JB  70.092456  -27  1  JO22fb  20  PA0O  JO33hg  198  47 
 2016-07-08 13:02  PA0O  70.092592  -12  -1  JO33hg  5  PA4JB  JO22fb  198  228


50 MHz wspr

 2016-07-14 12:22  PA0O  50.294514  -25  0  JO33hg  5  RX3DHR  KO94ks  2095  72  2016-07-14 10:30  PA0O  50.294518  -5  0  JO33hg  5  UY0LL  KN79xx  2043  88  2016-07-10 17:38  PA0O  50.294529  -20  -1  JO33hg  5  EA4GJK  IN80fw  1569  213  2016-07-07 14:48  PA0O  50.294512  -26  0  JO33hg  5  OZ7IT  JO65df  428  57  2016-07-11 15:24  OZ7IT  50.294518  -28  2  JO65df  5  PA0O  JO33hg  428  242  2016-07-08 10:38  ON5PU  50.294519  -8  1  JO21lh  5  PA0O  JO33hg  245  27  2016-07-07 14:00  DL2ZQ  50.294480  -26  0  JO42vj  0.05  PA0O  JO33hg  234  296  2016-07-10 18:04  PA0JME  50.294537  -20  0  JO21ri  10  PA0O  JO33hg  227  20  2016-07-07 15:40  PA0O  50.294518  -24  0  JO33hg  5  PA4MSA  JO22ge  185  230  2016-07-07 17:42  PA4MSA  50.294513  -8  0  JO22ge  5  PA0O  JO33hg  185  49  2016-07-08 08:10  PA0O  50.294530  -25  0  JO33hg  5  NL8992  JO32fl  89  187 

Comments

Archive

Show more

Popular posts from this blog

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its n...

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjuste...

TS790 cat interface

A CAT interface  for the old TS790 144/432/1292 tranceiver to work with N1MM  including the internal CW keyer DTR and "PTT" RTS and WSJT MSHV with "PTT" control Using the 3€ FTDI USB serial interface picture bottom page first i bought the Kenwood USB serial interface cable that cable has the TS790 special 6 pin DIN plug this interface works well ...as long as you cut the 4-5  wire bridge on the ACC din.. with the wire bridge it did go offline after 30 seconds or so  Kenwood interface cable with CH330 eBay 15€    This type Kenwood interface cable uses a tiny 6 pin USB CH330 chip  The driver is CH340 known for Arduino it workes in W7/10 64  It has only TX RX Usart function no DTR RTS available  The TS790 settings are 4800b 8bit data 2 stop  default  N1MM does not list the TS790 it has the TS890  but that one does not support modes the TS2000 does support freq and modes and let you switch 2/70/23 it seem...