Skip to main content

7O6T 7004 kHz somewhere down the LIDS

Last night  heard  a station with 7O6T callsign  fb signal strong 
but it seems to get worse every year.
What is gooing on in HAM radio? 
A constant jamming tuning  police  force made communication  impossible.  A festival of LIDS 

http://www.qsl.net/pa0oos/recall/7O6T_jamming_40.mp3

70MHz  ES  in the evening to EA5EF  500mW   and  EA5/G3GXS
IZ8DWF  IW0FFK peaked 59
SV8CS  very weak and briefly heard
25km south of me and in the rest of PA 59 reports heard given...
EA was a new DXCC  #16 
Opening was not so good in my QTH

Comments

Enno - PF5X said…
Yep, tried to make a QSO on 40m too yesterday evening. But in vein, too much morons. Only those who have beams and kW on 40m can make it ...

-- Enno, PF5X
May 8, 2012 at 2:31 PM
Post a Comment

Archive

Show more

Popular posts from this blog

70MHz IARU contest 19 20 Juli

 26 QSO in CW USB. Op zaterdag wat zwakke signalen uit Engeland, in de avond haast geen signalen meer. Dit was geen FT8 dat was duidelijk...  Op 70MHz is men in Engeland heel actief , voor een grote contest zoals deze IARU R1 24uur zoekt men daar goede locaties op zoals hier M0ICK/P IO84SA ik had QSO nr 4 Michael al 41! . Maar ook op de activity avonden op de Dinsdag avonden van de de maand zijn veel Engelse stations actief . Zo kon ik op de 2e dinsdag  van juni op 1 avond in een paar uur tijd 100QSO's op 70cm 432 MHz in CW USB hoofdzakelijk G's maar ook SM7 6 OZ SP OK DL   zoek  voor de agenda op : https://vhf-uhf.veron.nl/contesten/contestrobot/       Pas op Zondag later in de ochtend ging de band open eerst 9H1PA  daarna vrijwel heel Spanje ,het geduld werd beloond.  gemiddelde  haast 1200km  Ook EA op 70.200 in FM , helaas wel te dicht op USB waardoor een QSO haast niet mogelijk was.   4M station de IC7100 me...
Post a Comment
Read more

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its n...
8 comments
Read more

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjuste...
11 comments
Read more