Skip to main content

propagation reset

After some weeks of promising  28MHz openings.  All seems to be back to the start now.
Just last Sunday morning showed VK7AB 11x ! decoding me  and VK2KRR 1x  decoded
at 10meters.  The week before and after almost no signals at all.


Now i have my 7ele LFA yagi for 6M in the mast again. had to take down the 10/15/20/40 dipole  to keep it easy.


So I am back at 50MHz.  The LFA did show high SWR though.
Last year when I first had this beam it was a perfect match.
Then end of season i took it down stored it in house.
Could not tune the loop for a better match. Something is changed.


50MHz had some ES openings but i did not work anything yet.
I had WSPR running on it. YO6DN was the best distance sofar.
Now i can be QRV during working days...
The WSPR activity is low however   some decodes from F G I PA 


80m  is still good at Sunset 
yesterday VK7DIK 1x and tonight again around 19UTC



 2011-05-26 18:56  PA0O  3.594170  -28  0  JO33hg  5  VK7DIK  QE28sf  16731  84 
2011-05-26 19:08  PA0O  3.594106  -27  0  JO33hg  5  VK5PJ  PF95mk  15778  80

Comments

PE4BAS, Bas said…
Hallo Jaap, de zonnevlekken laten ons een beetje in de steek. Maar de ES is weer ok. 73, Bas
May 27, 2011 at 1:01 PM
Post a Comment

Archive

Show more

Popular posts from this blog

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its n...
8 comments
Read more

70MHz IARU contest 19 20 Juli

 26 QSO in CW USB. Op zaterdag wat zwakke signalen uit Engeland, in de avond haast geen signalen meer. Dit was geen FT8 dat was duidelijk...  Op 70MHz is men in Engeland heel actief , voor een grote contest zoals deze IARU R1 24uur zoekt men daar goede locaties op zoals hier M0ICK/P IO84SA ik had QSO nr 4 Michael al 41! . Maar ook op de activity avonden op de Dinsdag avonden van de de maand zijn veel Engelse stations actief . Zo kon ik op de 2e dinsdag  van juni op 1 avond in een paar uur tijd 100QSO's op 70cm 432 MHz in CW USB hoofdzakelijk G's maar ook SM7 6 OZ SP OK DL   zoek  voor de agenda op : https://vhf-uhf.veron.nl/contesten/contestrobot/       Pas op Zondag later in de ochtend ging de band open eerst 9H1PA  daarna vrijwel heel Spanje ,het geduld werd beloond.  gemiddelde  haast 1200km  Ook EA op 70.200 in FM , helaas wel te dicht op USB waardoor een QSO haast niet mogelijk was.   4M station de IC7100 me...
Post a Comment
Read more

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjuste...
11 comments
Read more