Skip to main content

474.2 kHz

lastnight 16 Feb.   many WG2XPJ  and  WD2XSH/17 decodes
no more >6000
  season  peak seems over  we had an early spring day
 for the first time drinking coffee in the garden  the days are much longer already.


A page full  decodes of the 3 USA experimental in FN  again
the 5656km barier could not be broken

2017-02-15 00:30  WG2XKA  0.475721  -29  -1  FN33lq  1  PA0O  JO33hg  5656  49 
 2017-02-14 23:48  WD2XSH/17  0.475648  -27  0  FN42pb  1  PA0O  JO33hg  5630  49 
 2017-02-15 04:14  WG2XPJ  0.475679  -20  0  FN34lp  1  PA0O  JO33hg  5587  50 
 2017-02-14 22:50  PA0O  0.475790  -30  0  JO33hg  0.2  EA7HPM  IM67xj  2017  214 
 2017-02-14 20:10  EA5DOM  0.475610  -23  0  IM98xn  1  PA0O  JO33hg  1713  15 
 2017-02-14 22:50  PA0O  0.475789  -17  0  JO33hg  0.2  OH8HTG/L  KP34di  1660  34 
 2017-02-14 22:50  PA0O  0.475790  -21  0  JO33hg  0.2  OH6GAP  KP22rd  1482  41 
 2017-02-14 22:50  PA0O  0.475789  -19  0  JO33hg  0.2  OH2EAT  KP20xw  1437  46 
 2017-02-15 00:08  EA3AER  0.475702  -26  0  JN12kd  0.2  PA0O  JO33hg  1268  11 
 2017-02-14 22:50  PA0O  0.475790  -14  0  JO33hg  0.2  LA2XPA/2  JP33wi  1124  3

Comments

Archive

Show more

Popular posts from this blog

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its n...

70MHz IARU contest 19 20 Juli

 26 QSO in CW USB. Op zaterdag wat zwakke signalen uit Engeland, in de avond haast geen signalen meer. Dit was geen FT8 dat was duidelijk...  Op 70MHz is men in Engeland heel actief , voor een grote contest zoals deze IARU R1 24uur zoekt men daar goede locaties op zoals hier M0ICK/P IO84SA ik had QSO nr 4 Michael al 41! . Maar ook op de activity avonden op de Dinsdag avonden van de de maand zijn veel Engelse stations actief . Zo kon ik op de 2e dinsdag  van juni op 1 avond in een paar uur tijd 100QSO's op 70cm 432 MHz in CW USB hoofdzakelijk G's maar ook SM7 6 OZ SP OK DL   zoek  voor de agenda op : https://vhf-uhf.veron.nl/contesten/contestrobot/       Pas op Zondag later in de ochtend ging de band open eerst 9H1PA  daarna vrijwel heel Spanje ,het geduld werd beloond.  gemiddelde  haast 1200km  Ook EA op 70.200 in FM , helaas wel te dicht op USB waardoor een QSO haast niet mogelijk was.   4M station de IC7100 me...

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjuste...