Skip to main content

Contest

Het zit niet mee voor de Velddag contest deelnemers.
Uitgerekend tijdens de velddag komt de regen met bakken omlaag.
Na weken en weken super velddag weer.  
De vorige veldag in juni  was ook al pech  met totale radio blackout juist in dat weekeinde.
Hoewel  later vanmiddag was het droog en zonnig uiteindelijk viel het toch nog mee.
Viel me op dat 10m later in de middag geheel stil werd geen enkel signaal meer.
Terwijl het toch open was geweest naar  UA9 UA0 JA BY en V55V/P ZS etc eerder.
Nu vanavond 10m totaal dicht slechts lokale WSPR spots.

De All Asian contest is helaas SSB  erg lage QSO rate.
Ze horen me niet  modulatie is altijd slecht ?   Misschien is 100W niet genoeg voor Phone.
  Please repeat pse again  was niet van de lucht QSO's  niet vooruit te branden.
Alleen 59 + age  uitwisselen dat zou toch niet zo'n probleem mogen zijn zo slecht waren de signalen uit JA en Asië  ook niet.
Duidelijk zit ik met 60  wel vaak hoger  dan de tegenstations...
Amper 25 QSO haalbaar voor een puntje voor de afdelings competitie
B7M  hoorde absoluut niemand op 10m waarschijnlijk  S9 QRM?  of geen ontvanger?
JT1BV ook al doof voor mij.

Opnieuw  spelling dictionary's NL DL installeren  in de browser die waren plotseling verdwenen.
Dat gaf een hangup en PC reboot nodig tijdens deze post.
Firefox ge-de-installeert  hopelijk minder vastlopers
De firefox geeft hier vaak hangups   misschien is  het de combinatie met MS IE mogelijk laat MS de andere browsers vastlopen om er zelf beter uit te zien?


Toch nog een aantal JA en BY op 28MHz
De big ones
JH4UYB JA6WJL  JA4DPL op 10m met redelijke signalen dat was al meer dan verwacht.


 

Comments

Archive

Show more

Popular posts from this blog

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its n...

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjuste...

TS790 cat interface

A CAT interface  for the old TS790 144/432/1292 tranceiver to work with N1MM  including the internal CW keyer DTR and "PTT" RTS and WSJT MSHV with "PTT" control Using the 3€ FTDI USB serial interface picture bottom page first i bought the Kenwood USB serial interface cable that cable has the TS790 special 6 pin DIN plug this interface works well ...as long as you cut the 4-5  wire bridge on the ACC din.. with the wire bridge it did go offline after 30 seconds or so  Kenwood interface cable with CH330 eBay 15€    This type Kenwood interface cable uses a tiny 6 pin USB CH330 chip  The driver is CH340 known for Arduino it workes in W7/10 64  It has only TX RX Usart function no DTR RTS available  The TS790 settings are 4800b 8bit data 2 stop  default  N1MM does not list the TS790 it has the TS890  but that one does not support modes the TS2000 does support freq and modes and let you switch 2/70/23 it seem...