Skip to main content

strongest solar flare of the year so far

EARTH-DIRECTED SOLAR FLARE: On Feb. 13th at 1738 UT, sunspot 1158 unleashed the strongest solar flare of the year so far, an M6.6-category blast. NASA's Solar Dynamics Observatory recorded an intense flash of extreme ultraviolet radiation, circled below:


Just one day after the PACC contest 
Propagation looks totally different
Sun is very active.
10m seems good !
I let WSPR mode running today and last night  ..every night
0.495891 WD2XSH/17 2x decoded but propagation was not good enough for  WD2XSH/6  in EM31  i hope one night it will.. 



TimestampCallMHzSNRDriftGridPwrReporterRGridkmaz
 2011-02-14 08:48  PA0O  28.126069  -21  0  JO33hg  5  VK2KRR  QF34mr  16351  73 
 2011-02-14 08:56  PA0O  28.126069  -17  0  JO33hg  5  VK2KRR  QF34mr  16351  73 
 2011-02-14 09:24  PA0O  28.126070  -17  0  JO33hg  5  VK2KRR  QF34mr  16351  73 
 2011-02-14 09:32  PA0O  28.126070  -20  0  JO33hg  5  VK2KRR  QF34mr  16351  73 
 2011-02-14 09:36  PA0O  28.126070  -19  0  JO33hg  5  VK2KRR  QF34mr  16351  73 
 2011-02-14 10:40  VK6ZRY  28.126098  -19  0  OF78wd  5  PA0O  JO33hg  14032  316 
 2011-02-14 10:44  PA0O  28.126189  -18  -1  JO33hg  5  VK6ZRY  OF78wd  14032  96 
 2011-02-14 08:38  PA0O  28.126161  -21  2  JO33hg  5  OY1OF  IP62oa  1254  326 
 2011-02-14 11:44  PA0O  28.126164  -19  0  JO33hg  5  OY1OF  IP62oa  1254  326



15 was already good last Saturday  with  Westcoast  CA  contacts  
Sunday  28MHz i was fruitless  CQ -ing
Just one day later  the band opened
How about some more WSPR activity in ZL and Oceania?


interesting 
http://www.k2kw.com/6y0aqrp/

I do not know  how to organize  this BLOG    much more must be possible
But i just don't understand Blog language  its Chinese for me...
I try to add a simple menu-bar  / link / picture / audio on the right side but I can not find anything in the menu to do this. Adding a gadget  yes.

   

Comments

Archive

Show more

Popular posts from this blog

2011-01-22 DIAMOND 2m 70cm 1m30 Colinear inside

Having relative poor signals on the local 70cm / 2m channels using this X50 Diamond collinear 70/2  1m antenna at a height of 25m. I needed to investigate what could be wrong. Measuring the cable only 3W is left for the antenna of the 10W 435MHz output from a IC451E The cable is 30m type H100 Z50 10mm outside diameter it is semi air-spaced but has an impossible 4mm² solid CU inner conductor not much air left. I preferred the H43 Z75 cable having lower loss and mechanical better ratio in conductor size. My antenna uses SO239 connector UHF type semi air spaced isolator.  3W should be enough for a comfortable noise free FM signal. But only 27km away at PA0A the signal is weak too weak something must be wrong? I made a simple reference dipole of 2x17cm CU wire. With this dipole the signals where totally worse. So the Diamond does work? I got curious to look inside. Maybe moisture penetration degraded the antenna. This  antenna is rainwater close in its n...

SPF5189z Low noise preamp 23cm

 14-4-2018 updated Above the low noise  preamp 50 - 4GHz    ebay  6€ Tested  2 small porto antennas 1 Baofeng UV antenna left   2nd best signal on PI2NOS 2 eBay DIAMONDSRH805S  wide band 144/432/1200  it works for its size as expected 3 piece of wire :   best signal in the setup... Unit under test at workbench. It was stable  50mA  at 5V   few days,  but sudden the current went up to 100mA And i could  no longer adjust it with the negative bias Voltage. The - Voltage went to zero and the SPF input port became low Z. This SPF5189z was broken  no oscillations, no input overload just it broke while i was receiving the PI2NOS 430.125 using a small antenna at the workbench. The specs of  SPF5189z  say it has an internal circuit  regulating the bias current. Replaced . again   with an other of the 5 spare SPF i have. The new one again could be adjuste...

TS790 cat interface

A CAT interface  for the old TS790 144/432/1292 tranceiver to work with N1MM  including the internal CW keyer DTR and "PTT" RTS and WSJT MSHV with "PTT" control Using the 3€ FTDI USB serial interface picture bottom page first i bought the Kenwood USB serial interface cable that cable has the TS790 special 6 pin DIN plug this interface works well ...as long as you cut the 4-5  wire bridge on the ACC din.. with the wire bridge it did go offline after 30 seconds or so  Kenwood interface cable with CH330 eBay 15€    This type Kenwood interface cable uses a tiny 6 pin USB CH330 chip  The driver is CH340 known for Arduino it workes in W7/10 64  It has only TX RX Usart function no DTR RTS available  The TS790 settings are 4800b 8bit data 2 stop  default  N1MM does not list the TS790 it has the TS890  but that one does not support modes the TS2000 does support freq and modes and let you switch 2/70/23 it seem...